Flying Shear

General Description

The equipment is design for cut-off to length the band according formats production programme once has been synchronized the speed of the shear with the speed of the band.

On the mainframe bank, made in fabricated carbon steel and tension relief, are assembled the following components:

  • Crops removing roll, elec. motor driven and equipped with lifting motion by hydraulic cylinder.
  • Idle rolls cradle and driven band conveyor for formats removal equipped with lifting drive to prevent band marking.

  • Flying shear for cut-off the band, travelling on rollers up to its speed has been synchronized with the band speed .
  • Top knife support shifting on bronze guides it is driven by eccentric's shaft, wheel and low inertia clutch.
  • Travelling A.C. motor drive equipped with precision gearbox.
  • Safety mechanical stroke ends and limit switches.
  • Special design four line edge knife.

Main Characteristics of a representative case:

Eccentrics shaft speed r.p.m. 100
Cutting - off capacity mm 2000 x 10
Cutting main motor power Kw 22
Max. travelling length mm 1.000
Travelling motor power Kw 48
INDECO´s logotype.

» METAL COIL SLITTING and CUT to LENGTH LINES
» LÍNEAS de CORTE LONGITUDINAL y TRANSVERSAL
» LIGNES de REFENDAGE et COUPE à LONGUEUR

INDECO
C/Zuaznabar, 111. Pol. Ind. Ugaldetxo 20180 OYARZUN - Gipuzkoa - SPAIN
Phone:+34 609 48 42 85 Fax:+34 943 26 01 78 - www.indeco.biz - e-mail: indeco@indeco.biz | legal