Slitting shears with tooling capstan
The slitting
shear function is sheet cutting on required width strips
and edge trimming by means of circular cutting tools.
Cutter and tool change on the slitting shear is fully automatic and
housing lock at working position is made by means of special "Rigid
Clamp" system developed by INDECO.
The change over of the used cutting tool set on the slitting shear
arbours can be done:
- 1- Manually in or outside the slitting line
- 2- Semi-automatically
- 3- Fully automatic
The main characteristics of the Fully-Automatic tool change
system are:
- High accuracy of slitting knife arbours.
- Presetting of 3 tool sets.
Tooling capstan features:
- Fabricated steel frame with turntable system
- Four coupled arbours for tools presetting
- Hydraulic motor rotary drive
- Shear arbour sets docking system
- The cutting tool set is changed on the tooling capstan by a hydraulic
pusher plate system.
- Driven motor for overlap adjustment
- Tool clamping by automatic hydraulic system
The fully automatic tool change time is shorter than 5 minutes.
The typical service application:
- Strip material as carbon steel, stainless steel, aluminium, cooper
and alloys of mentioned metals.
- Material strengths up to 1000 N/mm2
- Strip widths up to 2500 mm
- Strip gauge from 0,2 mm. up to 6 mm. (max. 15 mm.)
- Working speed up to 500 m/min.
Edge trimming shears
- For cutting damaged edges under required tolerances and with minimum
burr.
- The trimmed scrap is guided through hoppers to a scrap chopper or
scrap baler with a trim storage pit.
* Acrobat PDF Reader.